⚙️ Build Configuration
Leave blank for recommendation
Fresh: 50% / Recycled: 50%
⚡ Laser Settings
🌡️ Thermal Parameters
📐 Build Setup
📊 Build Estimates
🔧 Troubleshooting Guide
| Issue | Possible Cause | Solution |
|---|---|---|
| Warping / Curling | Thermal gradients, bed temp too low | Increase bed temp closer to Tg; slow cooling rate |
| Poor Surface Finish | Energy density too low, layer too thick | Reduce layer thickness; optimize laser power/speed |
| Weak Parts | Incomplete sintering | Increase laser power or reduce scan speed |
| Porosity | Too much energy, powder moisture | Reduce energy density; ensure powder is dry |
| Dimensional Issues | Wrong shrinkage compensation | Adjust X/Y/Z scaling factors; calibrate machine |